Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: GrandpawB on April 02, 2014, 10:54:11 AM
-
Downloaded Mach3 demo some time ago to try it out. Got my (licensed) Mach3 disc yesterday and installed. When I open up the program, at the top of the screen it still says "Mach3 Demo". I thought the licensed version would override the demo version. Can anybody explain why it didn't.
-
You probably didn't install it correctly.
Did you place the file named Mach1Lic.dat in the \Mach3\ folder?
-
Thank you very much. That was the problem.
-
hi there,
i have a big problem
i was using mach3 untill my computer crushed.
I wonder if i can install mach3 again and reload my old settings.
i have mach3mill.xml file and my secreen.set
do i need to re calibrate the steppers?
thanks all
Best Regards
Gokhan
-
If you have the xml for the profile you were using on the old computer then all your settings will be intact.
Hood
-
Thanks Hood
i have my mach3 on a new computer, works as before.
Best regards
Gokhan