Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: HimyKabibble on March 26, 2014, 02:19:51 AM
-
Okay, I realize this sounds crazy, but.... I would like to be able to toggle the Spindle DIR pin from a CB macro, using ActivateSignal/Deactivate. Is this possible? There is no CB constant defined for that I/O, but I'm wondering if there might be a way to "trick" it into working, perhaps by mapping another signal (like an OUTPUTx) to the same pin.
Regards,
Ray L.
-
PM sent.