Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jmorris on March 22, 2014, 06:32:50 PM

Title: Last line of code not being posted.
Post by: Jmorris on March 22, 2014, 06:32:50 PM
I have run a few machines before but pretty much just a button pusher.  All of them except the Cincinnati machines have had Fanuc or Fadal controls.

I have been looking for a machine to learn a bit more about programming and a friend came up with an ACT DMC III for me to play with but it came with no computer.  So I fix the ball screw on the Y axis and get a computer then download the free version of Mach3.

I then typed in some lines of code just to watch the axis move around a bit and noticed the last line of code entered (everything going back to zero) in the notebook was not being posted in the window inside Mach3 .  I can post screen photos if I am not being clear enough.

I have read the manual (a few times) and watched the videos that I could find but would like to ask help from folks that likely know the answer.
Title: Re: Last line of code not being posted.
Post by: Overloaded on March 22, 2014, 07:46:15 PM
Hello J,
  You have to hit the Enter (return) key after the last line.
Most folks end the file with a % on the last line to insure that a Return was done.
Then Mach3 will see it.
Russ
Title: Re: Last line of code not being posted.
Post by: Jmorris on March 22, 2014, 07:54:54 PM
Thanks.  That was easy.

It's all in syntax. I wish they had a class on this stuff when I was younger. Not like I am going to be using Fortran or Pascal anymore.