Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: gtonini on March 18, 2014, 10:54:59 AM
-
How hard is it to move the digitize led light from the diagnostic page to the program run page to make sure my probe is functioning properly. I'm running mach 3 version R3.043.066 ?
Thanks
Gary
-
Just use the screen editor of your choice. Probably best to create a new LED rather than move it.
-
I used screen4
open your file.set then simply copy and paste the led in the other page
greetings
moreno