Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: SirFinland on March 10, 2014, 07:13:34 AM
-
Hi!
How can I chnge the height in Mach3?
I'm using Vcarve and it's allways 25.4 for the Z How can I change that so it wont drill straiht in to the board?
Thanks!
-
You need to change it in V-Carve Pro.
-
As ger21 said, you need to change your settings in VCarve.
In the toolpaths tab, the first icon is "Setup material and rapid gaps". You can change the retract height there.