Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: derd83 on March 09, 2014, 11:45:07 AM
-
Hi all,
I'm struggling to get this g-code to run on Mach3 and I can't for the life of me see what's wrong with it. When I load it up, the shape doesn't appear in the view window. When I attempt to run it, Mach skips to the first G3 line and then stops the cycle. Any ideas?
-
Do you get a message in the status line ? "Radius to end differs ........" ?
Might need to change your I-J setting to Inc in gen config.
Russ
-
'radius to end of arc differs from radius to start. Block = G3 Y232.4269 I0.0 J88.0'
-
.................. change your I-J setting to Inc in gen config.
Russ
:)
-
got it, thanks!
-
No problemo.
A very common issue .... and search topic. :)
Russ