Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ips-asia on March 06, 2014, 12:26:25 AM
-
Hi there, which mach3 version should i buy for controlling 4-6 axis? And can someone recommend a up to 6 axis controller? I am going to build my own dektop 5 axis milling machine and mach3 is the only one suits me.
many thanks and best regards,
Jun
-
Jun,
There is only one Mach3 Software. Mach4 which is in development will have different levels of use.
As revisions to Mach3 are done it gets a different version number.
RICH
-
Hi Rich, thank you very much.