Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kolias on February 28, 2014, 08:43:59 PM
-
As per attached 2 images, my CAM program tells me that the toolpath is ok but when I import the code into Mach3 it has / cuts these circles around my part
What I do wrong?
-
I and J settings in mach general setting screen.
Alan
-
Sorry Alan, I dont see any I and J settings on the general setting screen
-
Config menu the General Config, in middle of page.
Hood
-
Guess I need a new pair of reading glasses, lol,
I set the IJ Mode from Absolute to Inc and now all is fine
Thanks Alan and Hood
-
kolias, Dont feel bad, crop circles seem to pop up around here about once a month ;-)