Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Jerry In Maine on February 20, 2014, 11:58:17 AM
-
Helping my brother - via email - venture into the CNC hobby. He's built a small machine and is now getting his electronics ready to go. His PC didn't have a OEM parallel port so he's ordered a PCI parallel card and will be connecting this to his breakout board.
Are there any caveats to be aware of when configuring Mach3 with add-on cards? I use an older PC that had its own parallel port so getting Mach3 going was a snap, so I have no experience with his setup.
Just trying to head off any potential problems in order to get him up and running with minimal fuss...
Thanks!
-
I believe as long as the output is 5v it should be alright.