Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: macatoms on February 11, 2014, 10:13:10 PM
-
Is there anyone that has made a post processor for Vectaric Aspire for a ROMAXX HS1?
I spoke to Ron at romaxx and he said the Vectaric was going to write one but thats been
long time ago.I would do it myself but I am not that smart!Any help would be appreciated.
Thanks Dave Mcadams
-
If it's running Mach3, then you just use the Mach3 posts in Aspire.
-
Iam using mach3 inch arc post and its adding t/c and my z axis is trying to drive past limits = and ?
-
typing mistake I mean +and-
-
Can you zip and attach the post you're using (.PP file) and the first 50 lines of your g-code?