Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rikduk on February 11, 2014, 02:00:10 PM
-
Anybody has this?
Usually, everything works fine, but:
Running a plasma, the THC is blinking green, but doesnt move the Z axis during cutting.
Close, restart mach3, it runs fine.
Its a pain, cause i start a piece, and dont know if it works or not...
The voltage goes waaay out of parameters, and yes, i pressed enter after entering voltage.
Is there a trick, has anybody had that experience?
Thank you