Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: marsheng on March 08, 2007, 04:49:41 PM
-
I'm thinking of retrofitting an Anilam LM lathe with Mach. Anyone in New Zealand done something similar? Please contact me at marshland.eng@xtra.co.nz
Thanks Wallace
-
Hi Wallace,
Good to see another user in NZ. I am in the Bay of Islands running a homebuilt 2400x1200 router with Mach3 so am not much help on the Anilam LM lathe. Just thought that I would make contact in case we can help out with software issues.
Alan