Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: snapajap on January 28, 2014, 11:29:39 PM
-
Ok, so I'm all proud that I have cut out a rectangle made of plastic and it has rounded corners. I have been trying like crazy to make the outside edges have a rounded edge (without taking to my router table).
Is it a roundover, fillet, bevel?? How can I incorporate this into my NFS programming?
I'm pretty dumb in this whole arena, so, bear with me please.
Thank you in advance.
-
If you are meaning the actual edges to have a rounded profile then you would need to use a corner rounding cutter.
Hood
-
snapajap,
You might be able to adapt the method in this video for outside edges. http://www.youtube.com/watch?v=NFQ1A37kcGA
John Champlain