Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: furkanyilmaz11 on January 27, 2014, 12:24:41 PM

Title: Edited Setup File with all settings for Mach3
Post by: furkanyilmaz11 on January 27, 2014, 12:24:41 PM
Hi Eveybody;

I am setting up my Mach3 for more than 15 time. And I am looking for a way for install everything in one setup package. I dont wanna setup things like xml files, graphics for screens, screensets etc. again.

I saw something like this in the CandCNC's setup files. After you clicked one install file everything was installed. With screens, graphics etc.
Is there an any way to do it. And maybe we can add cam program like sheetcam to this setup package. And we can finish everything in one setup package. Sheetcam with settings and Mach3 with all settings...

Thank you for all replys, helps...

I am sorry about my bad english..

regards,
Furkan
Title: Re: Edited Setup File with all settings for Mach3
Post by: ger21 on January 27, 2014, 02:02:12 PM
You can use an Installer like Inno installer to install .xml and screenset files, but you'll still need to install mach3 and SheetCAM separately I think.