Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kolias on January 19, 2014, 11:11:38 AM

Title: Status Line Min Z
Post by: kolias on January 19, 2014, 11:11:38 AM

About to get my 1st try to cut a piece and the status line on Mach3 says "Min-Z-.125"

Is this a warning that something is wrong or it is a statement to tell me that my depth is -0.125" ?

My max depth is 0.125" and I'm cutting a piece of MDF

Title: Re: Status Line Min Z
Post by: ger21 on January 19, 2014, 11:41:49 AM

It's a comment in your g-code from your CAM program.

Title: Re: Status Line Min Z
Post by: kolias on January 19, 2014, 03:55:44 PM

I found the line of this comment Gerry, Thanks