Machsupport Forum
Support => Forum suggestions and report forum problems. => Topic started by: bdn123 on January 09, 2014, 01:13:05 AM
-
hi i've ver3.043.066 running a laser, it does perfect but at exiting the mach crashs, no matter no problem just maintenance hours will be lost (essential for my job) , i save these at end of each session manual.
are there others with the same problem?
-
No problems here but I have reverted to using version 3.043.056.
Could you explain a bit more about "it does perfect but at exiting the mach crashes" how do you exit ?
Tweakie.
-
sorry about wrong place
i means i've no problem during running a job and when it finishes and i close mach, a window reports an error occurred (in fact mach3 doesn't exit properly)and i lose maintenance hours data. :-[
this happens for sessions which takes more than hour and so
-
Apologies, my poor choice of words. By 'no problems here' I meant that I have no problems with my setup of using Mach3 to control my laser. ;)
Perhaps try using an earlier version of Mach3 (some have reported having problems with ver. 066, although not with lasers). Earlier versions can be downloaded from ftp downloads tab http://www.machsupport.com/software/downloads-updates/
As said I now use ver. 056 and this is just fine for me.
Hope this helps.
Tweakie.