Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kolias on January 06, 2014, 08:24:47 PM
-
On Figure 5-7, page 5-11 of Mach3 manual, under Motor Control, what numbers normally do you put for "PWM Base Frequency" and "Minimum PWM"?
I can't find this info anywhere in the manual
-
I think these values would depend on the hardware you are using but then again I have never used PWM so take that with a pinch of salt :)
Hood
-
PWM frequency is typically 50Hz. Little to gain by going faster, and it can reduce resolution, depending on your kernel speed.
Regards,
Ray L.
-
I will use 50Hz, thank you both