Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: sharob27 on January 05, 2014, 09:27:53 PM

Title: Mach3 CRP4848 Setup Help Needed!
Post by: sharob27 on January 05, 2014, 09:27:53 PM

Hi Everyone!

I have assembled a CNC Router Parts CRP4848 over the last few months, and am having problems getting it running.  I can't seem to get the pre-wired Nema 23/G540 electronics to communicate with the Computer/Mach3.  Does anyone else use this system?  I was trying to make it work using Windows 7 32 Bit with a Rosewill PCI card added.  I have since switched to an older computer that uses Windows XP with an on board Parallel Port.  If anyone has any advice, Ports/Pins Configurations, or helpful tips, I would really appreciate it!      

Thanks,

Shaun

Title: Re: Mach3 CRP4848 Setup Help Needed!
Post by: Tweakie.CNC on January 06, 2014, 11:24:51 AM

Check through all the information here to make sure your configuration is correct (including the BIOS settings). http://www.geckodrive.com/geckodrive-step-motor-drives/g540.html

Tweakie.