Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Robaroni on January 05, 2014, 06:32:41 PM

Title: Mill Wizard, Mach3 doesn't see license
Post by: Robaroni on January 05, 2014, 06:32:41 PM

Hi,
I'm running Mach3 on my Win7 laptop and just installed NFS Mill Wizard. I seem to be having  a couple of problems.
One, Mach3 keeps telling me that Mill Wizard is unlic., which it's not. If I bring up the Mill wizard it shows my license as good. I tried to put a copy of the lic. in my Mach3 folder as "MillWizardlic.dat" but M-3 still doesn't recognize it.

The other problem I'm having is in Mill Wizard itself. If I start a new job, say a drill pattern, it doesn't show up on the blue screen in Wizard. I tried reloading the program but no good.

Latest version of Mill Wizard as of 1/5/14.

Thanks for your help,
Rob

Title: Re: Mill Wizard, Mach3 doesn't see license
Post by: Hood on January 06, 2014, 02:56:46 AM

You would be best asking in the section of the forum for the Mill Wizards as Ron usually monitors that.
Hood

Title: Re: Mill Wizard, Mach3 doesn't see license
Post by: Robaroni on January 06, 2014, 08:43:31 AM

Sorry, I missed that section. I'll do that.
Rob

Title: Re: Mill Wizard, Mach3 doesn't see license
Post by: Hood on January 06, 2014, 08:56:19 AM

No problem, just that  Ron will be more likely to see it there.
Hood