Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: boutje on January 04, 2014, 08:31:56 AM

Title: MPG problem
Post by: boutje on January 04, 2014, 08:31:56 AM

I have the following mpg problem with pokeys.

MPG/ pokeys is working fine in mach mill.

But i have also , with the same pokeys mpg pc , running a second profile.

And than the mpg is not working at all.

Title: Re: MPG problem
Post by: NeoTO on January 06, 2014, 12:10:23 AM

Hi, boutje

Due to some restrictions, PoKeys plugin for Mach3 supports 1 profile.

Regards,
Matevž

Title: Re: MPG problem
Post by: boutje on January 06, 2014, 02:55:50 AM

Ok, but in the second profile everything in the pokeys setup is the same.
All the buttons are working fine only the mpg not.

Title: Re: MPG problem
Post by: NeoTO on January 06, 2014, 04:12:49 PM

1. Did you enable MPG1 in port & pins configuration (there should be nothing setup in the fields for port and pin)?
2. What DRO is MPG mapped to in PoKeys configuration?