Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: guynamedbathgate on March 04, 2007, 06:31:12 PM
-
here is a funny one too. when I program a M6 Comand and give a tool number, say T3 . in the program. when I exicute this. it will change the tool number on the program run screen but it does not load the tool offset until I manually click on the tool number, change it to a different tool number and then change it back????. almost ruined a very expensive part. but thanks to my trusty big red button, the crisis was averted. anyone know how to correct this? :o
-
Hey GNBG,
I would download the latest version and see if that helps with this one and the run from here issue.
Brett
-
Just for fun try putting in your program:
Tx M06 Hx (put in the matching hiegth offset for that tool).
Scott
-
Try this:
Txx M06
G0 G90 G54 ********* Yxx etc, etc
G43 Hxx Zxx (H value matches T value)
And at end of tool, a G49 to cancel offset