Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Børge on December 28, 2013, 08:14:42 AM
-
Hi
Have a strange problem with Mach3
For every pass i makes it offsets the cutting patern with 0.5mm ??
Has this something with the motor tuning to do.
Thanks
Børge
-
Does it offset in one direction, or all directions? Can you post a pic of what it's doing?
-
Hi
It offsets in two directions
-X and -Y
Børge
-
Is the spindle perpendicular to the table?
-
Yes it is.
measured the Zaxis, and its 89.4 degrees to the table.
i will post a pictyre of what happends.
Børge
-
Here is a picture of the problem.
i tried to change the stepover, but dint do anything.
Could it be a motor tuning issue.
Børge
-
Try reducing the acceleration in motor tuning by 50%
-
Didnt help the issue
Børge
-
Hi guys, and thanks for helping.
It looks like i figured it out.
I reduced the stepping from full to half, and tried again.
This time it was ok.
Borge