Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mrich0908 on December 23, 2013, 03:47:37 PM
-
I have a part im making . In the center of the part it holds a bearing. Above that bearing is a lock ring to keep it in place. How do I go about write a code so I can use my slitting saw to make a spot for the lock ring to fit.
-
You could likely use a G12 or G13. for example if you move down in the centre of the hole the do a G13I5 it will move out in X by 5 units then cut round in a circle of 5 units radius and then finally move back to the centre.
Hood