Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kibrahacha on December 21, 2013, 09:39:53 AM

Title: Mach 3 stopped in middle of cutting file
Post by: kibrahacha on December 21, 2013, 09:39:53 AM

Good day. Am using mach 3 on a blackfoot cnc .Was cutting a  50 minute vcarve pro file and stepped out of shop for about 10 minutes. when returned mach 3 was stuck on 1 line of code about middle of cutting file .this is 1st time this has happened and I was not sure how to resolve this to complete cutting file.
What recommend if happen again in future?

Andy

Title: Re: Mach 3 stopped in middle of cutting file
Post by: ger21 on December 21, 2013, 02:40:28 PM

First thing you need to do is figure out why it happened.