Machsupport Forum

Mach Discussion => FAQs => Topic started by: Banger on December 15, 2013, 12:08:02 PM

Title: Motors not moving properly
Post by: Banger on December 15, 2013, 12:08:02 PM

Hi, I'm new to CNC so finding my way slowly. I have my motors running fine during a demo but when i try and jog them from the pc then the DRO's count but the motors dont move properly they appear to move 1 step per press of the button . They also fail to move during a test unless the plasma torch is switched on although again the DRO's and the position on the display are moving. I'm guessing they're linked ?