Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: 1601chief on November 12, 2013, 11:24:37 AM
-
What am I doing wrong? I am pushing the tool zero button in mach3 and it stops running at limit switch. I push reset but does not retract to 2" like I want. If I run the script from the edit script, it all runs fine. ???
-
Presume this is a custom screenset? If so then probably best asking the person that did it and wrote the script.
Hood
-
Using standard screen set but script from internet.
-
Probably best to ask the guy that wrote the script if you can find him. If not posting the script may get you some help, some are good with scripts, some are not, I am the latter :)
Hood