Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: magicniner on November 09, 2013, 12:09:40 PM
-
I feel left out!
Mach3 is working perfectly!
My mill and controller have had a variety of issues but even when I accidentally use the default BobCad 4 Axis Post I still get entirely useable code that makes nice parts, is there something I can do to remedy this lamentable situation?
TIA,
Nick ;)
-
;D ;D ;D
Tweakie.
-
Nick,
Sometimes the machine and software just waite a long time, they have infinite patience, then out the blue they may quitely show somethng which is representative of words from a movie ......" Tell me, do you feel lucky, just can't seem to remember how many times I let you run with no problems, now then, it may have been 10 times or ten months of running, just can't seem to recollect, so tell me Nick, feel lucky?" ;) :) :) :) :)
RICH
-
Wise words Rich,
I was touching wood and stroking a black cat the right way as I made my post ;-)
I have a later PC and an additional parallel port to implement which may leave me feeling a little more loved?
:D
Nick