Machsupport Forum

Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: pofo on November 02, 2013, 05:38:05 PM

Title: Stepping Moves Both Axis and Wrong Amount
Post by: pofo on November 02, 2013, 05:38:05 PM

I posted this in the General Discussion. Hood reviewed my .xml and thinks this problem may be related to the DSPMC.

Pressing the Tab key to get the pendant, I set the step function to .001". I set the Jog mode to Step. I hit any of  the left/right/up/down arrows on the keyboard. In all cases, when just pressing one arrow key, my mill moves -.005" on the X axis and -.02" in the Y axis. It doesn't matter what arrow I press, I get the same results. Both axis move in the same direction, the same amount.

But when setting the jog mode in the continuous mode, the arrows behave correctly.

Using a USB pendant, the same thing happens.

What am I doing wrong?