Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: KMX on October 09, 2013, 07:49:05 AM

Title: Two toolpaht previews
Post by: KMX on October 09, 2013, 07:49:05 AM

Hello!

Is it possible to have two toolpath previews on one screen (X-Y and Y-Z)? If not then how to set it to Y-Z direction? I use Mach3Screen V1.59a.

Regards, Denis

Title: Re: Two toolpaht previews
Post by: ger21 on October 09, 2013, 08:18:34 AM

You can't set the toolpath to a specific orientation. You can probably have two, but you'd need to manually rotate the views each time you started Mach3. Although you may not be able to change them independently.
Keep in mind that having two toolpaths might actually slow Mach3 down considerably.