Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jamied on September 27, 2013, 08:43:15 AM

Title: servo drive plugs
Post by: jamied on September 27, 2013, 08:43:15 AM

can any one identify these plugs on this servo drive , I need to get hold of some plugs to fit them , anyone know of anywhere to buy them , there are 14 pin encoder ones and 36 pin on the  input connector

thanks

Jamie

Title: Re: servo drive plugs
Post by: Ya-Nvr-No on September 27, 2013, 11:00:12 AM

go to omron web page there is a manual with all the part numbers

Title: Re: servo drive plugs
Post by: jamied on September 27, 2013, 11:44:02 AM

thanks but I have been on their site and it only lists complete cables not just plugs , i,m looking for plugs to configure my own cables there must be a supplier that supplies a plug as most drives have this type of plug

Title: Re: servo drive plugs
Post by: rdean on September 27, 2013, 12:41:49 PM

It is very hard to make out from the picture but take a look at these.
http://www.ebay.com/itm/50-Pin-MDR-Wire-mount-Male-Connector-Sanyo-Denki-YASKAWA-SERVOPACK-servo-drive-/300896188673?pt=LH_DefaultDomain_0&hash=item460ecf7901


Ray

Title: Re: servo drive plugs
Post by: mc on September 27, 2013, 12:46:55 PM

As previous poster, I'd guess Mini D Ribbon (MDR) connectors?

Title: Re: servo drive plugs
Post by: jamied on September 27, 2013, 01:37:38 PM

thanks guys , i,ll do a search on MDR plugs , here,s a close up

Title: Re: servo drive plugs
Post by: Hood on September 27, 2013, 02:25:18 PM

Yes that is what they are, Allen Bradley used to use them on the DDM drives and Samsung use them amongst others.
Here is a link to them from Farnell, you will get the 3M part number and be able to search your local suppliers with that.
http://uk.farnell.com/jsp/search/browse.jsp?N=2031+204641&Ntk=gensearch&Ntt=3m+mdr&Ntx=mode+matchallpartial
Hood

Title: Re: servo drive plugs
Post by: jamied on September 27, 2013, 04:28:59 PM

thanks guys , found them :) , first step on the long road to converting this hurco VMC ,