Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Dirty Steve on September 13, 2013, 11:53:04 AM

Title: Disable Generating Path on file load
Post by: Dirty Steve on September 13, 2013, 11:53:04 AM

Is there a way to disable Generating Path on file load? I am running Mach on a 3D printer and I am maxing out the specs on the laptop I use. File sizes are over 200MB.
If I hit cancel when the Generating Path dialog displays after the file loads, I can run the gcode without a problem. I regularly turn off the Tool Path display on these larger files as well.

thanks