Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: charliev on February 23, 2007, 07:46:46 PM
-
Hello:
Newbie here... can someone help me with signal definitions - else point me to a place in some documentation...?
X Home
X ++
X --
EStop
Limit Ovrd
I used the .XLM config file on this site for the MAXNC CL, but I found out too late that the config didn't assign the stop/limit switches - so I broke something... >:(
I suppose I need to assign the X, Y, and Z limnit switches to something... but what signal to they belong?
Thanks for the help.
-charlie
-
Hi, Charlie
There is a Mach3 manual that explains all of this, above, Tutorials, Documentations.
This will take you there, http://www.machsupport.com/documentation/M3M1_84-A2.pdf
Hope this Helps, Chip
-
Thanks for the help Chris, printing it now.
-charlie