Machsupport Forum
General CNC Chat => Show"N"Tell ( Your Machines) => Topic started by: cnctoolman on September 09, 2013, 12:58:54 AM
-
picked this nice little unit up over the weekend. couldn't beat the price one bit. It is actually quite sturdy. Was told that is what set up for Mach, but the reseller was just going off what was on the back of the machine. Need to figure out the ballscrews and run a few tests in Mach to see what settings need to be at. If anybody has any info on this machine it would be greatly appreciated.
-
a few more pictures
-
Looks like a good find. I had one of their controllers years ago but didnt know how to interface with it. Judging from the note, it appears to have been configured in Mach.