Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: tantan on September 08, 2013, 02:15:38 PM
-
I am testing my emco vmc100 with mach3 every works fine but i do not understand one thing
I use the g84 for tapping that works oke except that if the tap is at the bottom the spindle reverses but it takes a second or so before the z-axis moves up. I think that should be immediatly?
Thank you for your reply
Tantan
http://m.youtube.com/#/user/tantancnc?&desktop_uri=%2Fuser%2Ftantancnc (http://m.youtube.com/#/user/tantancnc?&desktop_uri=%2Fuser%2Ftantancnc)