Machsupport Forum
Third party software and hardware support forums. => LazyTurn => Topic started by: Spades on September 07, 2013, 12:23:49 PM
-
Hello,
I have a problem. The roughing job cuts far away from the workpiece. The finishing job cuts right.
In lazycam everything looks fine, but after loading the file in Mach3mill it looks strange.
The G-Code is wrong, so it must be a problem with lazyturn...
Please help me. :)
-
hi,
I encountered the same problem. did get the solution ? ???
-
MOHAMEDHELMI,
Have you read the Lazyturn Manual?
RICH
-
yes I finish reading it
but may be I messd some details .