Machsupport Forum
Third party software and hardware support forums. => CS-Lab => Topic started by: yahuie on September 06, 2013, 10:28:22 PM
-
The opto 22 output modules I was hoping to use are activated when current can flow from the opto22 logic control pin to logic ground. Can the IP/S output pins sink current when in the active low state? If not, what does happen in active low? It only needs to be able to sink 12 mA.
Thanks,
Bill
-
I do not think you can sink with the CSMIO outputs.
Hood
-
I got a reply from the CS-Lab folks who continue to be helpful. You're right. With the opto 22 relays I have, it would be possible to use their +24V out to control the Opto relays, but the mounting board I have doesn't allow access to the appropriate pin. I have G1 modules and a PB16T mounting rack. Looking for an appropriate rack if one exists.
Thanks for your reply!
Bill