Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: mole1 on August 30, 2013, 03:57:39 AM
-
Hi,
I am still using Mach2. I'd like to know is there macro-pump available in Mach2??? And if it is, then how do I activate it? I know how to do it in Mach3.
Thanks.
P.S: I know one option for me is to migrate to Mach3, but I've been using Mach2 for such a long time that I would not like to use any other version.
-
HUM let's see, Mach2 hum!!!!!!
Try Config,State,Bottom MIDDLE of page , check RUN macro pump. Then close and reload Mach2.
(;-) TP
-
Thanks for reply BR,
But I dont see macro pump setting in Config-->State. I am running Mach 2 V. 6.11 n
-
I am afraid I do not go back "THAT far". You may want to update to a little more MODERN verson of Mach2 .
(;-) TP
-
Macro pump
Sent from my iPhone using Tapatalk