Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: InfoSys on August 29, 2013, 02:54:31 PM
-
I am having issues with the spindle speed... I have attached the spindle config image and here are the issues:
1) With the current config spindle does not hardly spin faster than 5K even if it is specified to spin at 10k, 12k, etc.
2) I changed the PWMBase Freq. to 65 and the spindle will spin at about 10-12k but will not change even if specified (like above)
Is the something I am missing or a config change I should make??
(Just to note: we have a 5hp spindle with an 18k RPM max)
Thanks in advance!!
-
Post your .xml file if you can.
-
Check to make sure the drive is setup properly for max spindle motor speed.
-
Check that motor is tuned properly in config/motor tuning/spindle. Either steps per or velocity needs tweaking. Also your BOB may be a bit different. Make sure you are getting full voltage out of your BOB.