Machsupport Forum

Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: TDAY on August 27, 2013, 12:09:57 PM

Title: Addition to wizards
Post by: TDAY on August 27, 2013, 12:09:57 PM

Hello Ron,
 Wondering if a simple Hex operation can be added to the NMW? With option of hex size to be taking from points or flats.

Troy

Title: Re: Addition to wizards
Post by: Ron Ginger on August 27, 2013, 02:25:37 PM

yep, thats on the list, and should have been done by now. Actually, it will be a polygon op, any number of sides. It will be a cutout operation, not a full pocket. It will be like circle or rectangle, cut inside, outside or on the line.

Now that we are getting to the end of summer, and boating, I hope to be back to coding

Title: Re: Addition to wizards
Post by: TDAY on August 27, 2013, 06:43:05 PM

Sounds good. This will come in handy for making bolt heads and such.

O ya.... northern winters.... don't miss them at all. ;)

Thanks again,
Troy