Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DICKEYBIRD on August 18, 2013, 10:36:56 AM
-
Haven't used Mill much so it's probably my ignorance but I can't get this wiz to work. I just need a couple angled slots but the generated code just plunges the Z axis a few times with no X-Y moves at all.
Here's the code & I attached a shot of the wiz screen.
Thanks for lookin'
Milton
G20
G17 G40 G80
G00 Z0.2
G90 G54
S3000 M03
(insure IJ mode is incremental)
G91.1
G00 Z0.2
G00 X-1.8 Y-0.85
M9
G00 Z0.1
G01 Z0 F10
(plunge - center cut)
G20
G17 G40 G80
G00 Z0.2
G90 G54
S3000 M03
(insure IJ mode is incremental)
G91.1
G00 Z0.2
G00 X-1.8 Y-0.85
M9
G00 Z0.1
G01 Z0 F10
(plunge - center cut)
-
It works here I just tried it.
(;-) TP
-
Thanks BR; did you input the same numbers I used? If so, it must be something in my mill config or ??
I know nothing yet about cutter compensation. Could it be something I need to config to make it work...or does that wiz even use it.
-
Silly me. ::)
I clicked the "Ramp" button and the wiz & worked flawlessly. Dunno why it won't when "Plunge" is selected but I'm happy any way.