Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mvoros on August 18, 2013, 10:35:31 AM

Title: Fixture offsets not saved
Post by: mvoros on August 18, 2013, 10:35:31 AM
Hi,
I installed Mach R3.043.057 and for some reason it doesn't save the work offsets. When closing Mach, it ask if I want to save the fixture offsets, I say yes to it. But when I start up again the offset values are not there on the Offset page ether. I had the same issue with 3 other versions of mach. I'm using the ESS board. Any ideas?
Mike