Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mvoros on August 16, 2013, 03:24:02 PM
-
Hello All,
Can someone tell me the settings for this MPG? Well it worked, sort of before I switched to a different version of mach. Had to do the configuration from a scratch. When I open the fly out virtual Mpg and try to move in the X, I get this message: No zeroing while running. When I select the Y, than it gives this message: Nothing to feedhold. On selecting the Z and 4th, no status message. Also, if there is a G code program open, touching anything on the pendant, it starts the program, or runs away. This is maddening. Is there a newer Brain out there? I think the one I was told to use is about 10 years old.
Mike