Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Peeps on August 13, 2013, 02:52:38 PM
-
I can't seem to figure out what has happened to my Z axis. My X and Y are fine, but for some reason my Z lifts off the table way too high over the material. I reinstalled Mach3 thinkiking something was not right, butit still has the issue. Anyone ever have this before? .......thank you
-
Check the parameters you have for the Z axis for motor steps per unit.
(;-)TP
-
tool offsets possibly