Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bh on August 12, 2013, 11:21:08 PM
-
hi guys or gals i need some help... i bought a table a few years ago and had it up and running fine. i never really cut any thing with it,was in the middle of building a new house.. im done with the house and im ready to run this. bought a new computer for the table and cant get it to move... my screen shots are the same as before, but i think i have a parallel port issue. tried a new one that was listed on this site, no luck! i can turn the spindel on and off but that is all. seems i remember something abt flow,not shure if that is an issue! im located in northern illinois,anyone close that i cld pay to come help me out a lil... thanks 4 days of messing w it and im getting a lil crazy.... brian
-
Attach your xml and I will take a look and see if there are any obvious config issues.
Hood
-
thanks hood! i see you on all the time and was hopin you wld respond.. cld my "flow" be an issue? im pretty shure its a hardware issue, port problem? will send you my stuff, thanks again 4 your time!!!! brian
-
Not sure what you mean by flow.
Hood