Machsupport Forum
Third party software and hardware support forums. => SmoothStepper USB => Topic started by: xiaonu on July 31, 2013, 08:30:22 AM
-
why M3 home signal is on???The board No wiring ,But in the mach inside, M3 home signal is on。。。。
(http://p13.freep.cn/p.aspx?u=v20_p13_photo_1307232324178182_0.jpg)
(http://my.poco.cn/manage/images/blank.gif)
(http://image142-c.poco.cn/mypoco/myphoto/20130731/20/17350839720130731202617079.jpg)
(http://image142-c.poco.cn/mypoco/myphoto/20130731/20/17350839720130731202448019.jpg)
-
If there is no wiring it should not be enabled.
Brett
-
Sorry, this is the English forum so I Deleted your last 2 post.
Brett
-
If there is no wiring it should not be enabled.
Brett
My SS circuit board connected to the usb data cable only。。。。
-
OK, so either get the wires for you home and limit switches hooked up or disable them...... those pins will be floating until you do this.
Brett