Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ex-egll on July 20, 2013, 11:02:05 PM
-
Hi, recently I have started to get a message "mach3 jog mode disabled for mdi input" whenever I try to enter instructions into the MDI input box. Obviously in my playing around I have altered something, but can't determine what it was. Can anyone help resolve this please?
-
Can you attach your xml please and I will see if I get the same here and if so can find the problem.
Hood
-
Thanks Hood, although I dread to think what you may find in there as I have been "playing around" with the system for some time now... changing screens, new macros etc.
-
Ok go to General Config and choose Persistent Jog Mode .
Hood
-
Well that was quick, thanks Hood!
Change made and all is good again.
ex-egll
-
No probs, have also sent you a PM with some additional info.
Hood