Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: A.Davis on July 19, 2013, 01:17:54 AM

Title: Jogging off switches
Post by: A.Davis on July 19, 2013, 01:17:54 AM

Can any one help
I have built a small cnc router all good.
Home swithes have been wired in a daisy chain fashion and all work well.

Problem if I hit a stop either by jogging or during a program run I cannot get off the swith without shutting the motors down and manually winding off the switch.

Is there a setting in mach3 that allows me to jog off the switch without turning the thing off?

Many thanks
Adrian

Title: Re: Jogging off switches
Post by: jimthefish on July 19, 2013, 01:54:28 AM

Settings page, enable Auto Limit Override. Tick this and it will allow you to jog off the stops but make sure you move in the correct direction. Jim

Title: Re: Jogging off switches
Post by: A.Davis on July 19, 2013, 02:47:15 AM

Many thanks will give it a try