Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: wishmasterg on February 20, 2007, 11:50:54 AM
-
Hi Everyone,
New user here and I"m missing something and can't find it. When using my milling machine
the text that is being engraved is being cut from right to left, I would like it to be left to right.
Can anyone give me a clue how to make this happen? I really appreciate your help.
I found the problem, I check for past postings about the same problem and found I needed to
go to config/ports & pins/motor outputs/Dir low active for x axis and check for opposite of what
is was.
Thanks
Geo
-
Hi,, Geo
On the main screen next to Axis Pos Display, "Scale" click on the +1.0000 display, Enter -1.0 hit Enter key, this will flip your Axis.
Hope this Helps, Chip
-
Hey Chip,
Thanks for the reply, I have the axis going the right direction now.
I see its going to take time to learn all this.
Thanks again
Geo
-
To change the direction of the axis in the setup of the machine use the Homing and Limits Revers Axis setting.