Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Jimchi52 on July 10, 2013, 06:45:10 PM
-
When I look at my screen where it shows your program and table , my table shows up as a dotted line and I rotate the display it shows a thick table, just wondering if that is correct
-
It should, depending on the rev of Mach you have, show as a complete box defined by dotted lines. In other words it is showing X Y and Z extremities, so the "thick table" is not the table thickness but rather the travel extents of your Z axis.
Hood