Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jimchi52 on July 09, 2013, 07:57:43 PM

Title: ref home,tabke size and machine cords
Post by: Jimchi52 on July 09, 2013, 07:57:43 PM

I have my machine up and running and am trying to put in table size. also when I ref home it does not go to 000 in the front left ,it stops before it.And how do I set the machine cords?

Title: Re: ref home,tabke size and machine cords
Post by: Hood on July 10, 2013, 03:09:11 AM

Home Off value is used to tell Mach that the machine zero is not where the Home switch location is.
Hood